JVCC UHMW-PE-3 UHMW Polyethylene Film Tape: 1 in. x 36 yds. Natural/Translucent

Description

Product Highlights
JVCC UHMW-PE-3 UHMW Polyethylene Film Tape is a 3 mil ultra-high molecular weight polyethylene film with an aggressive acrylic adhesive. Its high chemical and abrasion resistance and extremely low coefficient of friction makes this a versatile engineering material for many severe service applications.
Materials slide freely over tape surface with no slip/stick tendency. High impact strength and shock-absorbing properties. Outwears Teflon many times over and is a good replacement when high-temperature resistance is not a requirement.
Applications include: rub strips on conveyors; bearings and sliding surfaces; chutes and hopper liners; dead plates; wear pads; guide rails; tool tables and fences; furniture and drawer slides/runners.
Standards Met: Chrysler MS-CH612, Ford ESB-M3G123-B, GM 6419M. Carrier/Backing: UHMW (Ultra High Molecular Weight) polyethylene film. Adhesive: acrylic. Release Liner: white paper.
Thickness: 9 mils (carrier, adhesive, liner) 5 mils (carrier, adhesive) 2 mils (adhesive) 3 mils (carrier) 4 mils (liner). Adhesion: 50 ounces per inch (to stainless steel test panel). Tensile Strength: 18 pounds per inch (longitudinal). Service/Operating Temperature: up to 300F. Elongation: 300%. Core: 3-inch diameter.
JVCC UHMW-PE-3 UHMW Polyethylene Film Tape
is a 3 mil ultra-high molecular weight polyethylene film with an aggressive acrylic adhesive. Its high chemical and abrasion resistance and extremely low coefficient of friction makes this a versatile engineering material for many severe service applications. Materials slide freely over tape surface with no slip/stick tendency. High impact strength and shock-absorbing properties. Outwears Teflon many times over and is a good replacement when high-temperature resistance is not a requirement. Applications include: rub strips on conveyors; bearings and sliding surfaces; chutes and hopper liners; dead plates; wear pads; guide rails; tool tables and fences; furniture and drawer slides/runners. UHMW polyethylene tape is used primarily in automotive and mechanical applications. Meets automotive specs: Chrysler MS-CH612, Ford ESB-M3G123-B, GM 6419M. Wound on a white paper liner. Made in the U.S.
NOTES: Sizes shipped will typically be the tape industry standard metric-cut sizes, i.e. 24mm for each 1 inch of nominal tape width ordered (rolls are approximately 5% narrower than the nominal size). This product's actual size is 25.0mm wide. This tape is typically cut to width from log rolls so most sizes ship on non-branded plain white cores. As with any adhesive tape product it is always the user's responsibility to determine that the product is suitable for their intended use; e.g. if you want to remove a product cleanly from a specific type of substrate please test on an inconspicuous area first.
Technical Information
- Core: 3 inch diameter
- Backing/Carrier: UHMW (Ultra High Molecular Weight) polyethylene film
- Adhesive: acrylic
- Release Liner: white paper
- Standards Met: Chrysler MS-CH612, Ford ESB-M3G123-B, GM 6419M
- Thickness: 9 mils (carrier, adhesive, liner) 5 mils (carrier, adhesive) 2 mils (adhesive)
- Adhesion: 50 ounces per inch (to stainless steel test panel)
- Tensile Strength: 18 pounds per inch (longitudinal)
- Service/Operating Temperature: up to 300F
- Elongation: 300 %